
Diesel and natural gas in the same cylinder, 520–1,100 kW, for rigs where associated or piped gas can displace liquid fuel. Switching between dual-fuel and diesel-only is done from the control panel while running.
Dual-fuel sets run on diesel pilot and natural gas main charge, so a site can start on liquid fuel and switch to gas once the supply is stable.
| Genset model | Engine model | Rated power (kW/kVA) | Voltage (V) | Frequency (Hz) | L×W×H (mm) | Net mass (kg) | Fuel |
|---|---|---|---|---|---|---|---|
| 400GF-S | G12V190Z_LSD-2 | 400/500 | 400/230 | 50 | 5820×2040×2779 | 14800 | Diesel / natural gas |
| 800GF-S | A12V190Z_LS | 800/1000 | 400/230 | 50 | 6398×2252×2569 | 18300 | Diesel / natural gas |
| Engine model | Rated power (kW) | Speed (r/min) | Heat rate (kJ/kW·h) | Lube oil (g/kW·h) | L×W×H (mm) | Net mass (kg) | Fuel |
|---|---|---|---|---|---|---|---|
| A12V190Z_LS | 1100 | 1500 | ≤10300 | ≤1.0 | 2950×1980×2206 | 10300 | Diesel / natural gas |
| G12V190Z_LS | 840 | 1500 | ≤11000 | ≤1.6 | 3055.5×1745×2422 | 5300 | Diesel / natural gas |
| G12V190PZ_LS | 800 | 1500 | ≤11000 | ≤1.6 | 4125×2130×2577 | 8100 | Diesel / natural gas |
| G12V190Z_LS-3 | 755 | 1300 | ≤11000 | ≤1.6 | 3055.5×1745×2422 | 5300 | Diesel / natural gas |
| G12V190PZ_LS-3 | 755 | 1300 | ≤11000 | ≤1.6 | 4125×2130×2577 | 8100 | Diesel / natural gas |
| G12V190PZ_LS-3 (low) | 715 | 1300 | ≤11000 | ≤1.6 | 3055.5×1745×2422 | 5300 | Diesel / natural gas |
| G12V190Z_LS-1 | 690 | 1200 | ≤11000 | ≤1.6 | 4125×2130×2577 | 8100 | Diesel / natural gas |
| G12V190PZ_LS-1 | 650 | 1200 | ≤11000 | ≤1.6 | 3055.5×1745×2422 | 5300 | Diesel / natural gas |
| G12V190Z_LS-2 | 560 | 1000 | ≤11000 | ≤1.6 | 3055.5×1745×2422 | 5300 | Diesel / natural gas |
| G12V190PZ_LS-2 | 520 | 1000 | ≤11000 | ≤1.6 | 4125×2130×2577 | 8100 | Diesel / natural gas |
Ratings are at ISO conditions on the specified gas; the pilot diesel share is set during commissioning.
Translated from the Dual Fuel Engine and Genset datasheet issued by BOMCO. Figures are factory values in SI units; the quotation confirms the exact build for your order.
We build Dual Fuel Engine and Genset in Baoji and test each unit against the figures above before it leaves the works. Our engineers set the rating point at commissioning to suit your fuel, altitude and ambient conditions, and we hand over the signed test sheet with the unit.
Tell us the duty you have in mind for Dual Fuel Engine and Genset and we will confirm which row of the table applies, or quote a special build when none of them fits.
Two working modes on one engine: dual fuel and straight diesel, changed over without stopping. That is the detail a catalogue listing usually leaves out, and the one that decides whether the unit suits the well in front of you.
Dual fuel is an economic decision at the wellsite, and the ability to switch back to diesel mid-shift is what makes operators accept it.

Rated 520 to 1,100 kW, switching from diesel to gas on the control panel while the set runs, the transfer a dual fuel generator set is bought for.
A diesel natural gas dual fuel engine keeps the diesel pilot for ignition and displaces the rest of the fuelling with gas from the field.

Compressor Packages

Power Control

190 Series Diesel Engines

190 Series Diesel Engines