
FCC slide valves for hot flue gas and fluidised catalyst: electro-hydraulic or pneumatic actuation, double body lining and tandem packing renewable in service.
Sizes, stroke time and actuator type follow the unit's piping and interlock; the rows below describe the standard construction.
Figures taken from the FCC Slide Valves data sheet issued by BOMCO. Values are nominal and the quotation confirms the build for your order.
A slide valve sits where a refinery has to throttle a stream that carries solids: hot flue gas with fines, or fluidised catalyst moving between regenerator, riser and standpipe. The duty is not a clean-fluid throttling job, so the valve is built around wear and heat rather than around a flow coefficient.
The result is a valve with a lined body, a flanged bonnet that keeps the joint even under thermal load, and a packing arrangement that can be renewed while the unit is still running.
We supply the valve, the actuator and the hydraulic power unit as one package, so the stroke time in our datasheet is the one the unit performs in your interlock. Our packing arrangement lets your crew renew the working set while the unit runs, and we hold liners and packing sets as spares because they set the maintenance interval. Where a line carries more solids than the standard build allows we change the liner grade rather than sell a valve that wears out early. Put the sizing sheet in front of us and the actuator selection comes back with it. Our spares list follows the liner grade we choose for your solids load.
Yes. The tandem arrangement puts two sealing stages in series, so the working set can be renewed at operating conditions while the second stage holds the seal.
From the stroke time the interlock needs, the thrust the gate requires at the differential pressure, and the fail-safe position. Electro-hydraulic actuation is usually the answer where the stroke has to be fast and repeatable.
The liner and the gate, in that order, because the solids in the stream abrade the flow path rather than the pressure boundary. The double lining exists so the shell does not have to be replaced with the wear part.
The valve, the actuator and the hydraulic power unit are delivered as one package, so the stroke time in the datasheet is the one the unit performs.
Spare liners and packing sets are quoted with the valve, since they are the parts that decide the maintenance interval.
Catalyst slide valve refinery duty puts solids through the gate at temperature, so the FCC slide valve we supply is lined for abrasion rather than for clean gas.

Energy recovery