
Panel built for the generator sets in this range, monitoring voltage, power and frequency, and raising audible and visual alarms before a fault takes the set down.
Two panel families cover the packaged sets: DPL for diesel, GPL for natural gas, biogas, coal-bed methane and waste gas.
Panel rating follows the generator it controls; the same cabinet is used for 50 Hz and 60 Hz builds.
Translated from the Diesel and Gas Genset Control Panel datasheet issued by BOMCO. Figures are factory values in SI units; the quotation confirms the exact build for your order.
We build Diesel and Gas Genset Control Panel in Baoji and test each unit against the figures above before it leaves the works. Our engineers set the rating point at commissioning to suit your fuel, altitude and ambient conditions, and we hand over the signed test sheet with the unit.
Tell us the duty you have in mind for Diesel and Gas Genset Control Panel and we will confirm which row of the table applies, or quote a special build when none of them fits.
Continuous monitoring of voltage, power and frequency. That is the detail a catalogue listing usually leaves out, and the one that decides whether the unit suits the well in front of you.
We build the panel around the set rather than buying a generic unit, because the trip logic has to match the engine it protects.

The generator control cabinet monitors voltage, power and frequency and raises audible and visual alarms before a fault takes the set down.

Gas Gensets

Compressor Packages

190 Series Gas Engines

190 Series Diesel Engines