Drilling, workover and well service equipment · Baoji, Shanxi, China
info@bomcochina.com Service centres: UAE · Kuwait · Oman · Saudi Arabia · Egypt
Support

Service & Support

Two hundred field service engineers, five regional centres and a spares route that starts at the model number on the nameplate.

Support 01

Commissioning

Every complete package is commissioned by an engineer who has run the same model before. The work covers mechanical alignment, brake and clutch setting, control logic verification against the works test sheet, and a supervised first job where the operator's crew runs the equipment with our engineer beside them.

For rigs, commissioning includes mast raising, substructure lift, drawworks brake tuning and travelling-block position calibration. For pressure control, it includes accumulator precharge, ram function sequence and choke manifold checks.

BOMCO keeps the commissioning report for every unit it ships, and its engineers read the previous one before the next visit to that rig.

Equipment test bench used before commissioning
A unit on the test bench before it goes to site: the same run-in, the same pressure hold, the same records the commissioning engineer signs.
Support 02

Spares and repairs

BOMCO service centres in the UAE, Kuwait, Oman, Saudi Arabia and Egypt act as the spare parts supplier for the drilling rigs and mud pumps working in their regions, holding fast-moving items in stock. Orders are matched to the equipment serial number, so a sheave, liner, valve assembly or BOP seal arrives as the part that fits rather than the part that looks similar.

Repair work is done either at the centre or on site, depending on the item. Drawworks, top drives and control units normally return to a workshop; masts, substructures and pump skids are usually repaired in place.

We hold a spares list for each model we have delivered, which is why our desk can quote from the serial number rather than from a photograph.

Rebuilt shear pump at the works
A shear pump rebuilt on the original skid. Reusing the mounting geometry keeps a field swap to a lifting operation, not a re-pipe.
Support 03

Training and diagnostics

Operator and maintenance training covers the control system, braking and hoisting practice, pump maintenance and pressure control function testing. Courses run at the BOMCO works in Baoji or at the customer's site, in English or with an interpreter.

Control systems on current rigs log parameters and faults. Where a site has network access, our engineers review those logs remotely before travelling, which shortens the diagnosis and often turns a two-week visit into a parts shipment.

Drive and control panels used in operator training
Drive and control boards in the training cell. Operators are taught on the panels we ship, not on a simulator that behaves differently.
Service pages

Scope, response and cost, stated page by page

Each page covers one service: what is included, how a job runs, and what the customer provides. Our engineers commission drilling rig and workover rig packages, rebuild mud pump fluid ends, test BOP stacks and support downhole lift strings from the same service desk.

Repair and Overhaul

Repair and Overhaul

Service · Repair

Spare Parts

Spare Parts

Service · Parts

Inspection and Certification

Inspection and Certification

Service · Inspection

Training

Training

Service · Training

Retrofit and Upgrade

Retrofit and Upgrade

Service · Retrofit

Rental and Leasing

Rental and Leasing

Service · Rental

Logistics and Packing

Logistics and Packing

Service · Logistics

Warranty and After-Sales

Warranty and After-Sales

Service · After-Sales

Emergency Response

Emergency Response

Service · Response

Talk to the team that commissions the equipment

Send the model and serial number from the nameplate, and the spares desk answers the same day.

Request a Quote →
BOMCO
Request a Quote