Drilling, workover and well service equipment · Baoji, Shanxi, China
info@bomcochina.com Service centres: UAE · Kuwait · Oman · Saudi Arabia · Egypt
Quality

Quality & Standards

Pressure-retaining and load-bearing parts are the two places where a shortcut becomes an accident. Both are tested rather than assumed.

Standards 01

Licences and standards

As an API licensed manufacturer, BOMCO holds fifty-seven product types across sixteen categories under API monogram licence, including API 4F for masts and substructures, API 8A and 8C for blocks and hooks, API 7K for rotary and swivel equipment, API 16A and 16D for pressure control, and API 11B for pumping units. The licences sit against the product rather than the company, so the monogram number on the nameplate traces back to the specific model you are buying. Six hundred national and industry standards have been written or revised here; two are international standards.

For sour service, wellhead and flow control trim is supplied in NACE-compliant materials with mill certificates traceable to the heat number.

Line pipe leaving the forming line at the Baoji works
Line pipe leaving the forming line. The API monogram is held per product type rather than per plant, and that is what the audit covers.
Verification 02

Testing before shipment

We non-destructively test the load-bearing parts — hook bodies, block frames, mast sections, substructure beams — before assembly, not sampled after it. Pressure-retaining bodies are hydrostatically tested above rated working pressure, and BOP control units are function tested with the accumulator set as installed.

Rigs assembled as complete packages are run through the control logic at the works: PLC sequences, travelling-block anti-collision, brake response, pump and rotary interlocks. We hand the same test sheets over with the unit, so commissioning on site starts from a known state rather than a first attempt.

Disc brake assembly on the test stand
A disc brake on the test stand. Load-bearing parts are proof-tested one by one; a sample certificate is not the same document.
For the buyer 03

What this means for a buyer

Ask for three documents with any quotation: the material certificate for pressure-retaining parts, the non-destructive test report for load paths, and the function test record for the control system. BOMCO issues all three inspection documents as standard, in the same pack as the test sheets.

Where a project calls for third-party inspection by a nominated agency, BOMCO accommodates the inspector's hold points rather than scheduling around them. We keep those records on file for every unit we ship, and we send them with the equipment instead of holding them until someone asks.

Drill pipe stacked in the yard, stencilled by grade
Drill pipe in the yard, stencilled with grade and heat number. The pipe that arrives can be traced back to the heat that made it.
Pipe forming line at the Baoji works
Pipe forming line. Strip is rolled, welded, sized and tested in one pass, which is the reason the dimensional records can be issued per joint.

Where to go next

Talk to the team that commissions the equipment

Ask for the material certificate, the NDT report and the function test record with any quotation.

Request a Quote →
BOMCO
Request a Quote